A preparatory work:
1.1 tools: brooms, wallpaper knife, gluing with kegs, brush;
1.2, according to the original specifications turf tile on the ground, be adjusted according to the site / Wall Recent
Second, the construction process turf adhesive Description:
2.1, shall require bonding turf floor / wall clean, dry and free of moisture and the surface
2.2, the ambient temperature should be chosen above 5 ℃ construction is appropriate, furthermore, not construction in the rain and rainy weather, otherwise it will lead to prolonged and even cause non-stick adhesive phenomenon.
Third, the specific construction process:
3.1, coating: Requires surface brushing uniform thickness, not repeatedly glue, otherwise there will be blistering, or even fall. Strictly control the thickness of the glue, pay attention to the appropriate speed glue, the glue should be applied to each of the two bonding surfaces to be bonded.
3.2, sticky and: according to the actual impact of prevailing temperature, humidity, barometric pressure and other conditions, the reasonable control of air-curing time. Generally within 10-30 minutes after the glue, the glue to dry in order to reach eight or nine hand-touch stick appropriate. When the cement bonding alignment requires a one-time, must not stick and later moved back in the bonded objects.
3.3, pressure: After re-bonding, remove the surface debris from the adhesive to the sides of the hard hammer real, full access to the surface dense bonding stronger.
3.4 curing: curing time is generally three days, testing the ultimate strength is usually ten days. It should be noted during curing maintenance, avoid exposure, flooding and mobile, has reached the best state bonding.
Fourth, Construction Notes:
4.1, the construction, the bonding adhesive must not be exposed for too long, due to the solvent evaporation will cause the adhesive too large construction.
4.2, such as the temperature is too low, can be hot after heating to 15--20 ℃, you can restore the original state, and the same performance.
V. Remarks .1 by the production process, paving tools, installation materials and other factors, there are changes in the construction process of the Department